AudioTechnica VM530EN/H Plug & Play

Her får du løsningen som gjør det raskt og helt enkelt å bytte pickup. Audio-Technica VM530EN, ferdig montert på et ATHS10BK Headshell. Og det til en meget fordelaktig pris. Audio-Technicas Plug & Play-modeller kommer ferdig innstilt for Audio-Technicas ATLP120-platespiller, og de fleste andre spillere med S-formet tonearm (f.eks. Technics SL1200/1210, Pioneer PLX-1000 og PLX-500, Onkyo CP-1050 osv.). Til andre modeller trengs bare en enkel justering. VM530EN/H DUAL MOVING MAGNET STEREO CARTRIDGE WITH ELLIPTICAL STYLUS WITH HS10 HEADSHELL Elliptical Nude profile diamond stylus VM type dual magnet system Para-toroidal coils improve generating efficiency Aluminium tapered cantilever Centre shield plate between stereo channels Pre-assembled with a lightweight aluminium headshell (AT-HS10) for a quicker, easier set-up High-end elliptical stylus model pre-assembled with a lightweight aluminium headshell (AT-HS10). The nude elliptical stylus helps to reduce the execution mass of the vibration system whilst offering increased frequency reproduction. AUDIO-TECHNICA’S INTERNATIONALLY-PATENTED DUAL MAGNET DESIGN REPLICATES THE STRUCTURE OF THE CUTTER HEAD. Instead of using a single, large magnet, the two magnets are arranged in the shape of a "V". The two magnets are positioned precisely to match the positions of the left and right channels in the stereo groove walls. Consequently, the VM design ensures outstanding channel separation, extended frequency response and superb tracking. Para-toroidal generating system Para-toroidal coils improve generating efficiency and offers superb linearity, since leakage of magnetic flux in this continuous and unitised magnetic circuit is low. Permeability of the cores is also optimised through the use of laminated cores. Centre shield plate reduces crosstalk A permalloy centre shield plate enables the effective separation of left and right channels, suppressing electrical crosstalk to below 40dB. This is similar to the actual crosstalk value found in the grooves of the record itself. PREASSEMBLED WITH HS10 HEADSHELL VM530EN cartridge is fitted onto a die cast aluminium HS10 Headshell suitable for 4-pin turntable arms. ELLIPTICAL NUDE STYLUS Elliptical diamond stylus follows the groove modulation with greater precision compared to a conical stylus, offering improved frequency and phase responses whilst reducing distortion. Type VM Type Mounting 1/2” centres Frequency Response 20 - 25,000Hz Channel Separation 27dB (1kHz) Output Channel Balance 1.5dB (1kHz) Output Voltage 4.0mV (1kHz, 5cm/sec.) Vertical Tracking Angle 23˚ Vertical Tracking Force Range 1.8 – 2.2g (2.0g standard) Stylus Shape Elliptical Nude Stylus Size 0.3 x 0.7 mil Stylus Construction Nude Round Shank Cantilever Aluminium Pipe Coil Impedance 2,700Ω (1kHz) Static Compliance 35 x 10-6 cm/dyne Dynamic Compliance 8 x 10-6 cm/dyne (100Hz) Recommended Load Impedance 47,000Ω Recommended Load Capacitance 100 – 200pF Weight 6.4g Dimensions 17.3 (H) x 17.0 (W) x 28.2 (L) mm Replacement Stylus VMN30EN Accessories Included Cartridge installation screws 5mm ×2 and 10mm ×2, Washer ×2, Hexagon nut ×2, Non-magnetic screwdriver ×1, Brush ×1, Lead wire set ×1