Neumann M149 Röhrenmikrofon

Produktteksten på denne varen er maskinoversatt. Trykk her for å se originalspråk (engelsk).  Den universelle high-end tube-mikrofonen med en unik lyd og et omfattende utvalg av innstillinger, inkludert 9 retningsegenskaper og et 7-nivå lavkuttfilter! Kapselen er avledet fra den legendariske U 47 og M 49. M 149-røret* er en variabel dobbelt-diaphragm-mikrofon. K 49-kapselen-kjent fra den legendariske U 47 og M 49 mikrofoner-blir fulgt av et rør som fungerer som en impedansomformer. I motsetning til tidligere konsepter - ved å bruke en transformator - kompletteres røret med en transformatorfri utgangskretsdesign. M 149 -røret kan således mate lange mikrofonkabler uten farge. To lysbildebrytere er plassert under den store, akustisk veldig åpne headgrille. Bryteren foran tillater valg ett av ni retningsmønstre. Slidebryteren bak driver et syv-trinns høypassfilter. Det tillater en veldig fin justering av avskjæringsfrekvensen. Byttbar rørmikrofon Transformatorless Circuitry Høy Utgangsnivå Trykkgradientomformer med M 49 -kapselen Akustisk veldig åpent trådnettbur Ni retningsegenskaper: Omni, Wide Angle Cardioid, Cardioid, Hypercardioid , figur 8, og en mellomposisjon hver 7-fold omskiftbar lavfrekvensrulling Tekniske-data < Ul> Akustisk driftsprinsipp: Trykkgradient Transduser Retningsmønster: Omnidireksjonell, vidvinkel kardioid, kardioid, hypercardioid, figur-8 pluss en mellomposisjon hver Frekvensområde: 20 Hz ... 20 kHz Følsomhet ved 1 kHz i 1 KOHM: 34/47/62 mv/pa*1) Rangert impedans: 50 ohm < Li> Nominell belastningsimpedans: 1 KOHMS Ekvivalent støynivå, CCIR2) 28/25/23 DB1) Ekvivalent støynivå, A-vektet*2) 16/13/11 db-a*1) signal-til-støy-forhold, CCIR2) (rel. 94 dB SPL) 66/69/71 dB*1) Signal-to-støyforhold, A-vektet*2) (Rel. 94 dB SPL) 78/81/83 dB1 Typisk SPL (rørkarakteristikk)*3): K

Neumann M149, Tube Microphone@+With nine different polar patterns, the M 149 Tube can be adapted to very different acoustic recording situations. Like its ancestors, it is particularly suitable for speech and vocals. This is due not only to its capsule, but also to the particularly low equivalent noise level of its modern circuitry.@+@+The M 149 Tube is used sideways. Its front is marked by the company label and the polar pattern switch. Below the capsule, a dome ensures that the sound from the upper half-space is dispersed so that there is no annoying interference with the direct sound components. To protect against structure-borne sound transmission, the capsule is elastically mounted. The capsule is surrounded by the large microphone head of the old M 49, but it is now acoustically more open and thus has a more neutral sound.@+@+There are nine characteristics to choose from: Omni, wide cardioid, cardioid, hypercardioid and figure-of-eight, each with an intermediate position.@+@+Unlike other tube microphones, the M 149 Tube combines a specially selected tube (triode) with the latest circuit technology. The objective of the development was to use the special transmission characteristics of a tube and to bring the amplified capsule signal to the microphone output in a controlled, undistorted and feedback-free manner. For this reason, the output transformer usually used with tube microphones is not used. Instead, a built-in amplifier especially suited for audio signals with very low distortion (THD < 0.002 % at ± 10 V), very low noise voltage and high current capacity is used to drive the different output loads. Thus, the tube is completely decoupled from the microphone output and becomes usable for input signal conditioning with its typical characteristic up to very high levels. Due to the high output power capacity, cable lengths of up to a total of 300 m are permitted for the M 149 Tube without having to accept any loss in signal quality. The tube amplifies the capsule voltage by approx. 10 dB to completely exclude residual influences of the downstream electronics. Nevertheless, a very high dynamic range is managed, since a peak output power of ± 10V at 20 mA is available. The ideal operating point (anode power, heater voltage) of the tube is stabilised during the entire lifetime. Voltage drops occurring in the microphone cable are detected and compensated by a sensor line. The heating of the tube is carried out gently by a regressive power limiter in order to ensure long service life.@+@+The slide switch on the back operates a high-pass filter whose cut-off frequency (3 dB) can be selected in half-octave steps between 20 Hz and 160 Hz. This way, interferences from air-conditioning systems or impact sound can be faded out in a very targeted way. In addition, the volume of a voice, for example, can be measured flexibly by using the proximity effect.@+@+The M 149 Tube is powered by its special N 149 power supply unit via an 8-core cable. At its...