Alone Surfboards Misfit 5.7ft 30.8L EPS

The MISFITDette brettet sin shape, outline og design kom etter ett samarbeid mellom Kelly Slater og Tomo. Shapen ble award winning, og mange shapere har brukt outline til sine egne brett.This board absolutely flies in smaller waves up to 6ft, it maintains a good amount of volume in the sizes and would be suitable for a range of surfers looking to really inject some bang into their surfing.The blunt nose makes the Misfit look like a modern small wave groveller when in fact the outline and overall profile results in a board more than capable in good overhead conditions and the round tail enjoys more speed and allows the rider to really push his turns on the face for radical performance. This simple and attractive shape has embraced ?less is more? school of thought with a generous planing surface and nothing to hinder it?s progress. If you?re looking for an every-day sled that?ll perform at your local break in conditions as well as on your travels in almost any conditions you?re likely to encounter at home and overseas then the Misfit is the board for you. SizesVolume5?5? x 19 1/8? x 2 3/8?27.7L5?7? x 19 5/8? x 2 1/2?30.8L5?9? x 20 1/8? x 2 5/8?34L5?11? x 20 5/8? x 2 3/4?37.6L6?1? x 21 1/8? x 2 7/8?41.1L     Recommended User: Intermediate / AdvancedSuitable Wave Height: 1-6 ftIdeal Spot: Beach Breaks / Point Breaks / Reef BreaksTail: Double Hip Squash TailFin Setup: Thruster ? Futures Futures, finner kan du trykke og kjøpe her :-)Forsterket med carbon strip+carbon patchesFor å fikse dings på disse brettene, kan du kjøpe denne pakken.TechnologyAlone Surfboards is a specialist in the manufacture of high performance epoxy surfboards with Carbon Flex and Fusion Flex technologies to guarantee the best results in the water.Epoxy Technology "eps"Epoxy surfboards came into the picture a bit later and it wasn?t until the 90?s that they really caught on. Typically, epoxy boards are made from EPS foam and are coated in epoxy resin. EPS foam is produced by feeding tiny polystyrene spears into a machine and then adding steam (with small amounts of pentane gas) to expand the beads and then mold them together. EPS is an open cell foam, meaning it?s extremely water absorbent. In order to keep the board water tight, shapers add extra layers of fiberglass and epoxy resin. Traditionally, most hand shapers don?t make boards from EPS foam but it is a great resource for pop-out boards.